The ERC-3000alpha series efficiently remove dissolved gases in the eluent.
Pressure sensor and leak monitor assure high degree of safety
Dead volume is minimized to 7mL/channel
Any pump can be used since differential pressure is low
Continuous degassing mode aids eluent preparation for high-sensitivity analysis
EMC and LVD compliance, with CE marking
A special synthetic membrane (degassing membrane) is used to selectivity remove dissolved gasses ; using the characteristics of the small molecular size of the dissolved gas with high mobility and affinity to the membrane.
When ion-exchanged water saturated with air at 25deg-C is put through at a flow rate of 3mL/min,
no bubble is observed at the outlet of the apparatus.
(Measured dissolved oxygen level at the outlet : 2ppm at flow rate of 3mL/min)
Max. flow rate
20mL/min for each channel (Eluent: 25deg-C pure water)
An open connector signal is delivered to the external output signal terminal,
When “PRES” and “LEAK” LEDs light.
W71 x D310 x H136 (mm)
AC 100 to 240 V, 50/60Hz
Power On/Off display
“POWER” LED lights, when the power is supplied.
Status monitoring function
“READY” LED lights, when the internal pressure in the vacuum chamber is below a predetermined limit.
Pressure monitoring function
“PRES” LED lights, when the internal pressure in the vacuum chamber does not reach a predetermined level within a predetermined time.
“LEAK” LED lights, when the liquid leaks in the apparatus.
The vacuum line is cleaned by air suction.
Vacuum pump operation switching function
NORM.: Controlled operation in normal run
CONT.: Continuous operation in case of high degree of degassing degassing
For the special solvents, such as fluorinated organic solvents, please contact Shodex or our destributors near you.
DEGASSERis the registered trademark of E.R.C Co.,Ltd.